iCarSoft CR Max

• Read and clear trouble codes | On most of the electronic systems such as engine, transmission, ABS, airbag etc.
• Support OBDII/EOBD | (Ten Modes of Operation)
• Full ECU Diagnosis
• Oil Light / Service Reset (OIL)
• Electronic Parking Brake (EPB) | System maintenance, deactivate and reactivate the EPB system for replacement and initialization.
• Battery Management System (BMS) | Register new battery to the BMS while battery replacement.
• Diesel Particulate Filter (DPF) | Regeneration control system, requests the DPF regeneration process while DPF blockage and turn off the DPF indicator.
• ABS Bleeding (BLD) | Release the air to restore ABS brake sensitivity, or relearn while ABS replaced.
• Airbag (ABR) | Crash data reset.
• Electronic Throttle Control system (ETC) | Relearn the throttle va value while clear or replace the throttle valve.
• Steering Angle Sensor (SAS) | Calibrate the steering wheel to straight ahead, or recalibrate SAS while steering part replacement.
• Fuel Pump activation (FPP) | Activate it when replace a new one.
• Air Filter (AFS) | Self-learning process after replacing the air filter.
• Body Stability (BSC) | Function supports routine maintenance of modules, for example reset or delete the adaptation values and start-up the unit.
• Engine (ECM) | Function supports routine maintenance of engine modules, for example reset or delete the adaptation values and calculate fuel consumption.
• Trans adaption (TCM) | Function supports routine maintenance of transmission modules, for example reset adaptation values and adjust the oil level.
• Air Suspension (SPS) | Reset electronic suspension air ride with the message system close all doors flip through message system go to suspension reset or off
• ACS (Air Conditioner) | Function supports routine maintenance of air condition modules. Air conditioning system adaption reset, rese air conditioning compressor, run in air conditioning compressor, stepper motor initialization.
• Head Lamp (LAP) | Maintenance and other related operations (Including AFS setting), and then perform this function for calibration.
• Tyre Pressure Monitor System (TPMS) | Function include displaying sensor IDs from the vehicle`s ECU, inputting TPMS sensor replacement lD and testing sensors.
• Engine ldle correction (IDL) | Can be executed when the idle speed fault is resolved. Adjust the engine speed of the car at idle speed.
• Adaption function | Allows you to perform adaptive learning / reset / calibration and other functions for each control module. It includes some important module data for parameter adjustment such as Remote Control Adaptation.
• Injector coding (INJ) | relearn the injector control parameter while the injector renewed or replaced.
• Actuation Test / Bidirectory Test | Used to access vehicle-specific subsystem and component tests.
• Special Functions | Seat, door window, roof etc.: Relevant functions for calibration after repairing or replacing.

Applies to most models which equipped with OBDII-16 DLC.
Certain functions may be limited from the vehicle manufacturer due to therequirement of a special factory access code.
The iCarsoft cr Max covers over 20 years of models, some functions may not beavailable on all years / models.